Home > News > Content

Ten Precaution During Use Of The Conveyor Belt

Apr 03, 2019

We all know that the use of conveyor belts is very extensive, there is no conveyor belt transmission, and many mechanical equipment is inoperable. But the use and operation of the conveyor belt is not sloppy.

For example, if the damaged conveyor belt is still running, it is extremely direct that the conveyor belt cannot be used, and secondly, it will damage the mechanical equipment, and another one may endanger personal safety.

Therefore, special attention must be paid to the use of the conveyor belt.

1. Note that the conveyor should be carefully inspected as required before starting. Do not connect conveyor belts of different varieties, models and specifications together;

2. When the conveyor belt is partially damaged, the artificial cotton should be repaired in time to avoid expansion;

3. Avoid the roller being covered by the material, causing the rotation to be ineffective, preventing the leakage of the material from being caught between the roller and the tape, paying attention to the lubrication of the movable part of the conveyor belt, but not the oily conveyor belt;

4. Prevent the conveyor belt from starting;

5. Adjust the cleaning device and scraper, avoid wear belt, avoid oil or grease and other impurities on the conveyor belt and rollers or rollers, as far as possible to avoid aging of the conveyor belt caused by rain, snow or sunlight;

6. When the conveyor belt runs off, measures should be taken to correct it;

7. Avoid the belt being blocked by the frame, pillars or block materials to prevent breakage and tearing;

8. During the operation of the conveyor belt, the tension should not exceed the tension of the conveyor belt design and avoid overloading;

9. Avoid using gas cutting machine or electric welding machine around the conveyor belt to prevent damage and conveyor belt. When the conveyor belt is damaged, it should be repaired in time;

10. The feeding direction must be consistent with the running direction of the conveyor belt. The feeding should be uniform to avoid excessive local load, and the material drop should be minimized.