Home > Information > Content

What are the replacement methods for rubber conveyor belts?

Jul 27, 2019

What are the replacement methods for rubber conveyor belts?


1. Release the pulling force of the belt conveying machine such as the ring-shaped EP rubber belt, and tighten it with the tensioning device, mark the beveled edge in the middle of the two tensioning devices, and cut the EP conveyor belt.

2. Cut the replaced belt section parallel to the beveled edge. Note that the belt body needs to be supported on the shelf in advance.

3. Calculate the lap length of the layered conveyor belt: the length of the front and rear connection * 2+ the length of the replaced section + the width of the EP rubber belt * 0.3 times the length of the chamfered section such as the layered fabric core rubber belt than the width Short time

4. After releasing the tension of the belt body, pull it together with a tensioning device, mark the oblique cutting line in the middle of the two tensioning devices and cut the layered tape; the determined excess length + single connection length and the beveled edge The size of the plug section cut in parallel: the length of the joint for front and rear connection * 2 + the width of the single belt as the intermediate section + the width of the loop conveyor belt * 0.3 times