Home > Information > Content

What are the joint operation procedures for nylon conveyor belts?

Aug 22, 2019

What are the joint operation procedures for nylon conveyor belts?


1. According to the actual size, and the length of the joint is broken, recognize the upper and lower parts, and correctly mark the end of the conveyor belt with the elastic line to connect the center line of the tape. (Verify that the centerline is correct with a right-angled transverse line) and draw a cut size line

2. Preparation of the lower tape: When the two ends of the tape are overlapped with each other, the upper tape should be aligned with the running direction, and the marks of the upper tape and the lower tape should be marked.

3. Draw a CB straight line with an angle of 90 degrees at the end of the tape, and cut the oblique line by tape width × 0.3 = about 16 degrees.

4. In the empty section (bottom edge), draw a line parallel to the diagonal line at 30mm from the tape, and keep the edge of the tape and mark it. The marked 30 mm wide strip of tape was cut into a slot with a knife and the portion of the cover layer was removed.